<b>7. </b>INSTALLATION. Electrolux EN3350MOX, EN3750MOX


Add to My manuals
56 Pages

advertisement

<b>7. </b>INSTALLATION. Electrolux EN3350MOX, EN3750MOX | Manualzz

10 www.electrolux.com

Problem

Side panels of the appli‐ ance are warm.

Possible cause

The food products tem‐ perature is too high.

Many food products were stored at the same time.

The FastFreeze function is switched on.

This is a normal state caused by operation of the heat exchanger.

Door was opened too fre‐ quently.

Solution

Let the food products tem‐ perature decrease to room temperature before storage.

Store less food products at the same time.

Refer to "FastFreeze func‐ tion".

Make sure that there is at least 30 mm of space be‐ tween each side of the appli‐ ance and the surrounding furniture when the ambient temperature exceeds 38°C.

Open the door only when necessary.

There is too much con‐ densed water on the rear wall of the refrigerator.

Door does not open easi‐ ly.

Door was not closed com‐ pletely.

Stored food was not wrapped.

You attempted to re-open the door immediately after closing.

Make sure the door is closed completely.

Wrap food in suitable pack‐ aging before storing it in the appliance.

Wait a few seconds between closing and re-opening of the door.

Only service is allowed to replace the lighting device. Contact your Authorised

Service Centre.

If the advice does not lead to the desired result, contact the nearest Authorised

Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

7. INSTALLATION

class indicated on the rating plate of the appliance:

WARNING!

Refer to Safety chapters.

7.1 Positioning

This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climate

Climate class

SN

N

Ambient temperature

+10°C to + 32°C

+16°C to + 32°C

advertisement

Related manuals