Operating the TV using the remote control. JVC SP-EXD1, EX-D1, GVT0143-008A

EX-D1[B].book Page 7 Wednesday, March 2, 2005 9:03 PM

This page is for when operating your TV using the remote control of this product.

Operating the TV using the remote control

Manufacturer

JVC

Akai

Blaupunkt

Daewoo

Fenner

Fisher

Code

01

02, 05

03

Okano

Orion

10, 31, 32 Panasonic

04, 31, 32 Philips

05

Manufacturer Code

Nordmende

13, 14, 18,

26 – 28

Saba

09

15

16, 17

10

13, 14, 18,

26 – 28

Grundig

Hitachi

Inno-Hit

Irradio

Magnavox

Mitsubishi

Miver

Nokia

06

07, 08

09

02, 05

10

11, 33

03

12, 34

Sanyo

Schneider

Sharp

Sony

Telefunken

Thomson

Toshiba

05

02, 05

20

21 – 25

13, 14, 18,

26 – 28

13, 14, 18,

26 – 28, 30

29

NOTE

Manufacturer’s codes may be changed without notice.

You may not be able to operate a TV produced by the manufacturer shown above.

5

Release TV.

For TV operation

Operate the remote control by pointing it towards the TV.

Turn ON/OFF the power.

Change channels.

Setting the manufacturer's code

1

Slide the remote control mode selector to the TV side.

Adjust volume.

2

Keep pressing down TV.

NOTE

Keep pressing down

3

Press ENTER.

TV until Step

4

is complete.

4

Press number buttons (1-9, 0).

Ex.:

For a Hitachi TV: Press 0, then 7.

For a Toshiba TV: Press 2, then 9.

If there are more than one manufacturer’s codes, try them in turn and select the one that causes the product to work properly.

100+

9

Select channels.

*1

Alternates between the previously selected channel and the current channel.

Switch TV and video input.

*1 Make sure to slide the remote control mode selector to the TV side in advance.

NOTE

When the batteries are replaced, perform the manufacturer's code setting again.

7