Sequence of the cooking programme when using Automatic switch-off. Miele H 5061 B, H 5361 B, H 5461 B, H 5051 B

More about manual operation

Sequence of the cooking programme when using Automatic switch-off

The following will appear in the display:

Before the programme starts

– The cooking function and selected temperature

– "Start at" and the start time

After the programme has started

– The heating-up phase until the set temperature is reached

– Once this temperature is reached, a tone will sound (provided this is activated - see "Settings - Volume -

Buzzer tones").

After the heating-up phase

– The "Time left" counting down can be followed in the display,

Shortly before the end of the programme

– The oven heating switches off.

– The cooking programme continues using residual heat. The residual heat in the oven is sufficient to complete the cooking process.

– "Use residual heat" will show in the display.

– The cooling fan continues to run, as does the hot air fan if a "Fan" setting has been chosen.

After the programme has finished

– The cooling fan will continue to run for a while after the oven has been switched off to prevent any humidity building up in the oven, on the control panel or in the oven housing unit.

The fan is temperature controlled and will switch off automatically. You can change the default setting for this (see "Settings - Cooling fan runon").

– To save energy, the oven will switch off automatically if it is not used again within a certain time.

The timing depends on the settings selected (cooking function, temperature, duration).

Changing or deleting an entered cooking time

^

Touch the OK sensor.

^ Select "Duration" with the OK sensor.

^ Use the ?

sensor to set the time to

"-:- -".

If there is a power cut, all data entered will be deleted.

At the end of the cooking programme

– The hot air fan switches off, depending on the cooking function being used.

– The "Prog. finished" message will appear in the display.

– A tone will sound (provided this is activated - see "Settings - Volume -

Buzzer tones").

32