10.4. Data Reset. Entec ETMFC610

Multi-Function Control ETMFC610

10.4. Data Reset

http://www.entecene.co.kr

Move to “MAINTENANCE / DATA RESET” . This menu resets COUNT and Maintenance data.

Passcode 3 certification is required to enter “CLEAR SAED DATA” menu.

MAINTENACE / DATA RESET

[DATA RESET]

>1.ETMFC610 COUNT

2.OPERATION COUNT

3.FAULT COUNT

4.PQM COUNT

5.COM’ COUNT

6.COUNT ALL

7.INTERRUPT TIME

> 8.BATT. CAPACITY

9.CONTACT WEAR

10.ENERGY

11.MAX DEMAND

12.PEAK CURRENT

13.COMM BUFF

14.USER COUNT

15.ABOVE ALL

[CLEAR EVENT]

EVENT CLEAR SUCCESS

Saved Data Reset

Select an item to delete and press [ENT] button.

If deleting is completed, “EVENT CLEAR SUCCESS” message is displayed.

*. NOTE )

1.

‘OPERATION COUNT’ is reset by a set value in “MAIN

MENU/ GLOBLA SETTING/ MONITERING/ OPERATION

COUNT” .

2.

‘CONTACT WEAR’ is reset by a set value in “MAIN MENU/

GLOBLA SETTING/ MONITERING/ CONTACT WEAR” .

3.

‘BATT. CATPACITY’ is reset by a set value in “MAIN MENU/

GLOBLA SETTING/

MANAGEMENT” .

MONITERING/ BATT

4.

Except ‘OPERATION COUNT’ , ‘CONTACT WEAR’ and

‘BATT CATPACITY’ , all data is reset for 0.

15. ABOVE ALL

All count data of 1 ~ 14 menus are reset at once.

10.5. Controller Information

Move to “MAINTENANCE / CCU INFO” to confirm ETMFC610 controller information.

In this menu, information such as option, version and serial number of current ETMFC610 is displayed.

EN HANCED TEC HNOLOGY 334