TV operation. RCA 27F501TDV

NOTES:

•

If a channel with no broadcast is selected, the sound will automati-

•

cally be muted.

If a station being viewed stops broadcasting, the TV will automatically shut itself off after 15 minutes.

5L00101AE(18-21) 19

TV operation

1

To turn on the TV/VCR/DVD, press POWER.

2

Adjust the volume level by pressing VOL + or – . The volume level appears.

3

Set the TV/CABLE menu option to the appropriate position. (See page 22.)

VOLUME 32

TV - VHF/UHF channels

CABLE - CABLE TV channels

4

Press the number buttons to select the channel.

Channels can be instantly selected by using two buttons.

(for example, to select channel 2, press “0”, then “2”. If you press only “2”, channel selection will be delayed for a few seconds.)

For channels 10 and above, press the 2 digits in order. For example, to select channel 36, press “36”.

You can also press “0”, then the remaining 2 digits. For example, to select channel 12, press “012”.

For 3 digit numbers, press the 3 digits in order. For example, to select channel 120, just press

“120”.

2/25/04, 3:07 PM

19

TV operation (continued)

CHANNEL +/–

Press and release CH + or – . The channel automatically stops at the next channel set into memory.

For proper operation, before selecting channels, they should be set into the memory. See pages 22 and 23

“To memorize channels”.

CALL

Press DISPLAY/CALL to display the current informations on the screen.

Press DISPLAY/CALL again to clear the call display.

• Channel number or VIDEO mode.

• Stereo or SAP (second audio program) audio status.

• Audio output status.

QUICK VIEW

This button allows you to go back to the last channel selected by pressing QUICK VIEW. Press QUICK

VIEW again to return to the last channel you were watching.

TV/VCR

8 : 47 AM MON

STEREO SAP

CH 125

00 : 00 : 00 SP

NOTE:

To listen through the headphones, insert the headphones (not supplied) with a 1/8" mini plug into PHONES jack on the front. The sound from the

TV speaker is muted.

MUTE

Press MUTE to switch off the sound.

The unit’s sound will be silenced and

“MUTE” will briefly appear on the screen. The sound can be switched back on by pressing this button again or one of VOL + or –.

SLEEP

To set the TV/VCR/DVD to turn off after a preset amount of time, press

SLEEP on the remote control. The clock will count down 10 minutes for each press of SLEEP (120, 110,

...10, 0). After the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is operating.

To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to 0.

20

5L00101AE(18-21) 20 2/25/04, 3:07 PM

MUTE

SLEEP

120