STM8S007C8
Note:
Pinouts and pin descriptions
The slope control of true open drain pins cannot be programmed and by default is limited to
2 MHz.
As shown in the rightmost column of the pin description table, some alternate functions can be remapped at different I/O ports by programming one of eight AFR (alternate function remap) option bits. Refer to
Section 8: Option bytes . When the remapping option is active,
the default alternate function is no longer available.
To use an alternate function, the corresponding peripheral must be enabled in the peripheral registers.
Alternate function remapping does not effect GPIO capabilities of the I/O ports (see the
GPIO section of the family reference manual, RM0016).
DS8633 Rev 6
25/93
25
