Transfer CODESYS project to PIO. Beijer Electronics NA-9379

Programmable I/O (PIO) NA-9379, Basic setting

KI00341 2014-10

9.5

Transfer CODESYS project to PIO

A gateway needs to be created in order to communicate between the PC and the PIO

• Double click the “Device(NA9379)” option under “Devices”

• Select the “Communication setting” options

• If no gateway present, create one by selecting “Add Gateway” (choose default value)

• Highlight the gateway

• Press “Scan network” and wait until scanning is done

• All CODESYS devices on the network will be listed below the gateway.

The last two numbers (02) in the “id” [0001.C002] are the last group in IP-address

NOTE!

If you don´t find your “CODESYS devices”, try to “Add Device” www.beijer.se

21 (35)

Programmable I/O (PIO) NA-9379, Basic setting

• Select the device that the project will be downloaded to and press “Set active path”.

This device will be highlighted by a bold font.

• Download the project to the device (TxB SoftControl) which was selected above menu “Online” select “Login”.

KI00341 2014-10

• The project will now be downloaded to the device (the RUN led are flickering)

• Set the PIO to RUN with the switch on front at PIO.

RUN/STOP of PIO can also bedone with “F5” or the symbol (if the switch are ON)

• When all are green (see picture), the PIO is running! www.beijer.se

22 (35)