Quick Start Guide. GAI-Tronics VoIP Titan Illuminated Crossing Telephone (1193 ), Illuminated Crossing Phone VoIP Titan

4. Quick Start Guide

Full programming and configuration details are contained in the Configuration guide, available from www.hubbell.com/gai-tronics/en/voip-support

The factory defaults will generally be sufficient in most cases, but the following steps must be taken as a minimum:

•

Provide an Ethernet connection and power (either 24-48Vdc or PoE)

•

Ensure that a DHCP server is available on the network, and that the IP address allocated to the telephone can be discovered (DHCP is the normal factory default provisioning method). If DHCP fails (or there is no DHCP server) the telephone will revert to a default IP address of 192.168.1.2 after a few minutes

•

Using a web browser, browse to the IP address.

•

When prompted, enter the user name and password (Defaults: user & password )

•

From the Home Page, select the Configuration section, and from that the

VoIP Accounts main page

•

On the VoIP Account 1 Information sub-page, enter: o The user name (the extension number or name used by the SIP server for this telephone) o Domain name, Proxy domain name and Register domain name

– set all of these to the domain name or IP address of the SIP server o Auth user password – set to the authentication password for the extension on the SIP server if required. o Ensure Provider enable and Register enable are both set to enable. o Update the changes, then save the changes. o Check that the registration state changes to “registered”

•

Program any speed dial memories using the User Configuration main page

6 VoIP Titan Illuminated Crossing Telephone.