Pole mounting. GAI-Tronics VoIP Titan Illuminated Crossing Telephone (1193 ), Illuminated Crossing Phone VoIP Titan

6.3. Pole mounting

Kit No 100-02-0208-001

10

This accessory is for mounting GAI-Tronics telephones on to the side of round poles of 100mm to 200mm diameter (4 - 8in), or on to square or rectangular section uprights of 100mm to 150mm (4

– 6in) across the mounting surface.

NOTE:

Banding straps (large scale worm-drive clamps) are not included in this kit and must be obtained separately. For details of where banding can be obtained, refer to GAI-Tronics.

1. Using a suitable tool, punch out the 4 outer holes in the rear enclosure, taking care not to damage or dislodge the plastic bushes.

2. Attach the pole mounting clamp assemblies to the rear enclosure using the M6 x 25 screws provided, pushing the screws through from inside the phone.

3. Tighten nuts to a torque of 4.5Nm (3.3lb-ft) max.

IMPORTANT: avoid the use of power tools.

Spinning the nuts too quickly can cause a rapid increase in heat which can cause the nuts to seize as a result of galling or cold-welding.

Note: only use the outer four holes, and ensure that the screws seat properly in the plastic bushes to avoid water ingress.

4. Ensuring that the glands are at the bottom, pass a proprietary banding strap round each of the pole mounting clamps and the support pole. Tighten securely.

5. Continue the installation by making the appropriate connections

(section 7.4) and re-fitting the face plate.

6. Re-tighten the straps firmly and trim off any excess band material.

For security the driving head of the band may also be sawn off.

VoIP Titan Illuminated Crossing Telephone.