Wall mounting. GAI-Tronics VoIP Titan Illuminated Crossing Telephone (1193 ), Illuminated Crossing Phone VoIP Titan

3. Select the appropriate sized gland:

Use the smaller gland for cables diameters 4 - 7mm (0.16

– 0.27in).

Use the larger gland for cable diameters 8 - 13mm (0.3

– 0.5in).

4. From the outside of the case, insert the selected gland into the threaded cable entry hole and tighten, so that its sealing washer is compressed against the enclosure surface.

5. Proceed with chosen mounting method below

IMPORTANT

Glands are essential to clamp cables and to ensure a weatherproof seal.

It is the installer’s responsibility to make sure they are correctly selected and fitted. Failure to do so could result in an unsafe installation.

As standard, Titan with rear enclosure is supplied with 2 differently sized cable glands with sealing washers, 4 flanged sealing bushes and a 3mm Allen key.

6.2. Wall mounting

8

1. Using a suitable tool, punch out 4 holes in the rear enclosure, taking care not to damage or dislodge the plastic bushes. Only four of the eight holes are required - the outer ones are recommended. The inner holes are provided to be compatible with older-style mounting posts, and should be left intact if not used. If the inner holes are used they must be fitted with the supplied plastic bushes.

VoIP Titan Illuminated Crossing Telephone.

WARNING:.An unsafe condition could occur (and your warranty will be invalidated) if :-

1. Any fixing hole made in the rear enclosure is left unused.

2. Any additional holes are drilled into the telephone enclosure.

3. Plastic bushes are not used on all fixing holes.

2. Mark the wall with hole centres based on the dimensions shown

(145 x 270mm, 5.7 x 10.63in). If necessary offer the rear enclosure up to the wall to check alignment. Do not use the enclosure as a template for drilling.

3. Drill holes in the wall on the marked positions. Select appropriate screws, wall plugs etc., for the type of wall, bearing in mind that the weight of the complete phone is around 5kg (11lbs).

IMPORTANT : USE ONLY countersunk-headed fixing screws. Check that screws seat properly in the plastic bushes to ensure a watertight seal. Do not use excessive tightening force, as this may crack the case.

4. Ensure that all four plastic flanged bushes are in place and the rear enclosure is screwed tightly to the surface to prevent any water ingress through the punched holes.

5. Complete the installation by making the appropriate connections

(section 7.4) and re-fitting the face plate.

VoIP Titan Illuminated Crossing Telephone. 9