advertisement
1.
Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2.
Select the Save&Send tab.
3.
Switch on Log Out After Saving .
17.4.1.6
Setting whether to Discharge Patient Automatically after Saving Data
You can selects whether to automatically discharge the patient after saving data in Spot
Check mode. To do so, follow this procedure:
1.
Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2.
Select the Save&Send tab.
3.
Switch on or off Discharge Patient After Saving .
17.4.1.7
Setting whether to Automatically Save NIBP Measurements
You can selects whether to automatically save the NIBP measurements after NIBP measurement completes. To do so, follow this procedure:
1.
Select the Main Menu quick key
→
from the System column select Maintenance
→
input the required password
→
select .
2.
Select the Save&Send tab.
3.
Switch on or off Auto Save After NIBP Measurement .
17.4.2
Setting Items about Sending Data
17.4.2.1
Setting Clinician Login as Required for Sending Data
You can set clinician login as required for sending data. To do so, follow this procedure:
1.
Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2.
Select the Save&Send tab.
3.
Switch on Clinician Required .
17.4.2.2
Enabling Clinician Login Verification before Sending Data
You can set the monitor to verify if the clinician login information matches with the information in the database before sending data. To do so, follow this procedure:
1.
Select the Main Menu quick key → from the System column select Maintenance
→ input the required password → select .
2.
Select the Save&Send tab.
3.
Switch on Clinician Match Required .
VS 9 Vital Signs Monitor Operator’s Manual
17 - 7
advertisement