Wear Versa 4. Fitbit Zip 291835, 291837, Versa 4 Smart Watch, 291836, VERSA 4 BLACK GRAPHITE, VERSA 4 WATERFALL BLUE PLATINUM, FB523, VERSA 4 PINK SAND COPPER ROSE, Versa 4

Add to My manuals
81 Pages

advertisement

Wear Versa 4. Fitbit Zip 291835, 291837, Versa 4 Smart Watch, 291836, VERSA 4 BLACK GRAPHITE, VERSA 4 WATERFALL BLUE PLATINUM, FB523, VERSA 4 PINK SAND COPPER ROSE, Versa 4 | Manualzz

Wear Versa 4

Wear Versa 4 around your wrist. If you need to attach a different size band, or if you purchased another band, see the instructions in

"Change the band" on page 15

.

Placement for all-day wear vs. exercise

When you're not exercising, wear Versa 4 a finger's width above your wrist bone.

In general, it's always important to give your wrist a break on a regular basis by removing your watch for around an hour after extended wear. We recommend removing your watch while you shower. Although you can shower while wearing your watch, not doing so reduces the potential for exposure to soaps, shampoos, and conditioners, which can cause long-term damage to your watch and may cause skin irritation.

For optimized heart-rate tracking while exercising: l

During workouts, try moving the band higher on your wrist to get a better fit.

If you experience any discomfort, loosen the band, and if it persists give your wrist a break by taking it off.

12

l

Wear your watch on top of your wrist, and make sure the back of the device is in contact with your skin.

Fasten the band

1. Place Versa 4 around your wrist.

2. Slide the bottom band through the first loop in the top band.

3. Tighten the band until it fits comfortably, and press the peg through one of the holes in the band. If you use one of the last two holes in the smaller band, we recommend swapping to the larger band for a more secure fit. For

13

instructions, see

"Change the band" on the facing page .

4. Slide the loose end of the band through the second loop until it lies flat on your wrist. Make sure the band isn’t too tight. Wear the band loosely enough that it can move back and forth on your wrist.

Handedness

For greater accuracy, you must specify whether you wear Versa 4 on your dominant or non-dominant hand. Your dominant hand is the one you use for writing and eating. To start, the Wrist setting is set to non-dominant. If you wear Versa 4 on your dominant hand, change the Wrist setting in the Fitbit app:

From the Today tab

Wrist  Dominant.

in the Fitbit app, tap your profile picture Versa 4 tile

14

Wear and care tips

l l l l

Clean your band and wrist regularly with a soap-free cleanser.

If your watch gets wet, remove and dry it completely after your activity.

Take your watch off from time to time.

If you notice skin irritation, remove your watch and contact customer support.

For more information, see fitbit.com/productcare .

For more information, visit the Fitbit Wear & Care page .

Change the band

Versa 4 comes with a small band attached and an additional large, bottom band in the box. Both the top and bottom bands can be swapped with accessory bands, sold separately on fitbit.com

. For band measurements, see

"Band size" on page 63 .

Fitbit Sense, Fitbit Sense 2, and Fitbit Versa 3 bands are compatible with Versa 4.

Remove a band

1. Turn over Versa 4 and find the band latches.

2. To release the latch, slide the flat button toward the band.

15

3. Gently pull the band away from the watch to release it.

4. Repeat on the other side.

Attach a band

To attach a band, press it into the end of the watch until you hear a click and it snaps into place. The band with the loops and peg attaches to the top of the watch.

16

advertisement

Related manuals

Download PDF

advertisement

Table of contents