“Memory Stick” Player. Pioneer deh-p900hdd

43

“Memory Stick” Player

D

isplay and indicators

FORM 1

q w r

FORM 2

q e t t e r y q

Source name w

Bit rate indicator e

Track number r

Track title t

Play time y

Track artist name

B

asic operation

The “Memory Stick” player plays one

“MagicGate Memory Stick (MG Memory Stick)” at a time. (See page 77.)

1. Press OPEN to open the front panel.

2. Insert a “Memory Stick” into the MS loading slot until it clicks into position.

MS loading slot

Access lamp

3. Close the front panel.

MS EJECT button

4. Press VOLUME to extend the VOLUME outward.

• When you press VOLUME, it extends outward so that it becomes easier to turn. To retract VOLUME, press it again.

5. Turn VOLUME to adjust the volume.

6. Press

2

or

3

to select a track.

Pressing

3 skips to the start of the next track.

Pressing

2 once skips to the start of the current track. Pressing again will skip to the previous track.

• If you press and hold

2 or

3

, you can perform fast forward or reverse.

7. Press OPEN and then press MS EJECT to eject the “Memory Stick”.

• The access lamp lights while data are being written. Never remove the “Memory

Stick” while the access lamp is lit, as otherwise data may be destroyed.

• Be sure to close the front panel after removing the “Memory Stick”.

WARNING:

• Do not use with the front panel left open. If the front panel is left open, it may result in injury in the event of an accident.

Note:

• You can select “Memory Stick” as the source by pressing SOURCE when a “Memory Stick” is loaded in this product.

• When the front panel is open, multi-function buttons are not available.

• Do not insert anything other than a “Memory Stick” into the MS loading slot.

• A “Memory Stick” left partially inserted after ejection may incur damage or fall out.

• If the “Memory Stick” player cannot operate properly, an error message (such as “ERROR-30”) appears on the display. Refer to “Understanding

“Memory Stick” player error messages” on page 81.

• During playback of music data with a limited number of playbacks, fast forward and reverse are not possible, so that the number of playbacks can be managed correctly.

• When TA interruption occurs during playback of music data with a limited number of playbacks, the number of playbacks is decreased by one. This can be prevented by setting TA interruption to OFF in advance.