error messages. Pioneer deh-p900hdd

U

nderstanding auto-equalizing error messages

When correct measurement of car interior acoustic characteristics is not possible using the autoequalizer, an error message may appear on the display. If an error message appears on the display, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again.

Display

ERROR CHECK MIC

Cause Remedy

Microphone is not connected.

Plug the supplied microphone securely into the jack.

ERROR CHECK SPEAKER The microphone cannot pick Confirm that the speakers are up the measuring tone of the connected correctly.

front and rear speakers.

Correct the input level setting of the power amp connected to the speakers.

Set the microphone correctly.

ERROR CHECK SYSTEM The surrounding noise level Stop your car in a place that is as is too high.

quite as possible, and switch off the engine, air conditioner or heater.

Set the microphone correctly.

U

nderstanding built-in CD player error messages

When problems occur during CD play, an error message may appear on the display. If an error message appears on the display, refer to the table below to see what the problem is and the suggested method of correcting the problem. If the error cannot be corrected, contact your dealer or your nearest Pioneer service center.

Display

ERROR- 00, 44

ERROR- 11, 12, 17, 30

ERROR- 11, 12, 17, 30

ERROR- 12, 17

ERROR- 10, 11, 12, 17,

30, A0, B0

ERROR- 23

Cause

All tracks are skip tracks.

Dirty disc.

Scratched disc.

Unrecorded disc.

Electrical or mechanical problem.

Remedy

Replace disc.

Clean disc.

Replace disc.

Check the disc.

Turn the car ignition ON and OFF, or switch to a different source, then switch back to the CD player.

Replace disc.

Can’t play

HEAT

The CD format cannot be played back.

MP3 file cannot be played back.

CD player overheated.

Switch to other MP3 file.

No audio

Turn off the CD player and wait until the CD player cools down.

Replace disc.

Nothing has been recorded or the CD format cannot be played back.

78

79

Additional Information

U

nderstanding music server error messages

Display

ERROR- 23

SERVER ERROR- 23

ERROR- 24

SERVER ERROR- 24

SERVER READ ERROR

SERVER WRITE ERROR

TEMP

Cause

Music server’s hard disc malfunction.

Music server malfunction (due to damaged data, etc.)

ERROR- 30, A0, A1, B0

SERVER ERROR- 30, A0,

A1, B0

Can’t play

Electrical or mechanical problem.

Expired

The music data cannot be played back.

The music data has exceeded the playback limit (playback time or number of plays).

No audio

No PlayList

REMAIN 0

No recording on music server.

No playlist file for music data that can be played back in selected playlist mode.

Too large check out number was stipulated.

Somehow track information was not read in correctly.

There is something wrong with the music server.

Somehow track information or

FAT was not written correctly.

Abnormal temperature inside this product.

Remedy

Repeat operation.

Turn the car iginition ON and OFF, or switch to a different source, then switch back to the music server.

Turn the car iginition ON and OFF, or switch to a different source, then switch back to the music server.

Switch to other music data.

Switch to other music data.

Record tracks on music server.

Switch to other playlist mode.

Check in tracks that checked out on another “Memory Stick”. (Check in/check out)

Turn the car iginition ON and OFF, or switch to a different source, then switch back to the music server.

Repeat operation.

Wait until normal operating temperature is restored.