Setting the FM tuning step. Pioneer deh-p900hdd

S

etting the FM tuning step

Normally, the FM tuning step is set at 50 kHz during seek tuning, however, it changes to 100 kHz when the AF or TA function is on.

You can set the FM tuning step to 50 kHz even when the AF or TA function is on.

1. With the source turned off, press and hold 1.

2. Press NEXT and then press FMstep to select the FM tuning step mode.

3. Press the corresponding button to select the desired tuning step.

Button Tuning step

50K 50 kHz

100K 100 kHz

S

etting the warning tone

The warning tone sounds to remind you to detach the front panel. (Refer to page 11.)

You can turn the warning tone function on or off.

1. With the source turned off, press and hold 1.

2. Press NEXT and then press DT-WRN to select the warning tone mode.

3. Press DT-WRN to turn the warning tone on.

“ON” appears in the display.

• Press DT-WRN again to turn the warning tone off.

Note:

• The FM tuning step remains set at 50 kHz during manual tuning.

• The tuning step returns to 100 kHz if the battery is temporarily disconnected.

70