advertisement
Adjustment Routine
The position of the punching on the time card is defined when programming the unit.
Generally in the factory. But it may happen that the punching is not printed exactly in the right position due to manufacturing tolerance and especially card tolerances.
With the adjustment routine the position of the punching on the time card can be adjusted in vertical and horizontal direction and adapted to new card dimensions.
The clocking can be adjusted within -5.0 mm and +4.9 mm in both directions, from the left to the right and from top to bottom.
The adjustment is executed via the adjustment value which must be between 00 and
99. This adjustment value corresponds with the dimensions of the unit printed on this page. The adjustment value pre-programmed ex factory is 50 and this value means no change in print position. Changes are in steps of 0.1 mm.
Minimum dimensions of the card:
- left card edge 3.5 mm
Card lift / Line change
To check the position, the first punching of a payroll period is printed into the first column and the first line.
The position can be changed by pressing "R" (+) and "E" (-) in 0,1 mm steps.
Column change
The adjustment of the column change resp. the horizontal position of the punching identical to the adjustment of the card lift / line change but the left card edge is used as reference line.
Proceeding
1.
2.
Unit is switched on.
Press " E" first, then "S". Keep both keys pressed for about 2 seconds until display shows the adjustment value for card lift.
3.
D3
Adjust card lift / line change
Display = Adjustment value
50 = 0 mm, no correction
Value range: 00 - 99
38 Adjustment Routine
advertisement
