1-1 Role and Operation of NT20. Omron NT 600M-LB122-V1, NT 20M-DT121-V2, NT 20-IF001, NT 20-ST128, NT 20, NT 20M, NT 20-ST122-V1, NT 20-ST121-EV3, NT 20-ST121-E, NT 20S
Pubblicità
Pubblicità
2
Role and Operation of NT20
Section 1-1
1-1 Role and Operation of NT20
NT20 is a programmable terminal used to display and transmit the information in an FA site. The following gives a general description of the role and operation of the NT20 for those who use a programmable terminal (PT) for the first time.
Production Line Status
Monitoring
The NT20 displays real-time information about the system and equipment operating status, etc.
Production Control
1994/1/25
Product
NT20M/NT20S
560 units
NT600M
441 units
Today's target
Current Production
305 units
275 units
% achieved
54.5 %
63.0 %
Messages
The NT20 warns of system or equipment failures and prompts the appropriate remedial action.
Assembly line B is defective.
Alarm
-
Positioning pin
Panel Switch Functions
Setting touch switches on the NT20 allows workers to use the NT20 as an operating panel. Production data input to the NT20 or the Host can be transmitted to a PLC.
Electroplating Control
Transport
Clamp
UnClamp
Role and Operation of NT20
Section 1-1
1-1-1 Operations of NT20
Displays Screens
The information to be displayed (screen data) can be created on a computer by using the Support Tool and stored in the NT20. The screen data can be displayed on the NT20 in response to the instructions from a Host or touch switch operation.
Host
The screen data designated by instructions from Host or touch switch operation is displayed.
Receives Data from a Host
The NT20 can be connected to the Host using the host link or NT link communications method to enable reception of the required data from the Host.
Host link, NT link, RS-232C,
C200H direct communications
Host
Sends Data to a Host
Data input through a touch panel can be sent to a Host.
Host
Touch panel
ON/OFF information, numeric data, etc.
Screen Data
The screen data to be displayed on the NT20 can be created by a computer by using the Support Tool. Connect the NT20 to a PC/AT with an RS-232C cable so that the screen data are transferred to the NT20.
RS-232C
Create screen data.
PC/AT
(Support Tool)
Screen data
When the host is connected at serial port A, the personal computer is connected only when transferring screen data between the
NT20 and NT Support Tool.
3
Scarica
Pubblicità