Walking Sling. BHM Medical v4

Always use the same color loop on the shoulder straps for both sides of the sling.

Use the same color loop on the leg straps for both sides of the sling.

3. Ensure the patient’s arms are over top of the sling and that it is not caught on any obstructions (wheelchair brake or handle).

4. See “Operation“ section for next step.

Walking Sling

Designed to assist people with limited ability to walk, this sling helps support and assist in rehabilitation. Fully padded with a security buckle, the sling is comfortable and simple to use. The user must have some weight bearing ability. Fits all BHM’s ceiling lift models as well as the Ergolift mobile lift. Available sizes: S, M & L. Weight capacity is 272 kg (600 lb).

Do not use the Walking sling on a patient who does not have weight bearing ability and good muscletone in their shoulders and neck.

Check with the patient's physician, nurse or medical specialist before using this sling.

ERGOFIT SLINGS

SLING SIZES AND PRODUCT NUMBERS

SMALL MEDIUM LARGE

CHEST SIZE 68-89 cm

(27-35”)

89-107 cm 107-125 cm

(35-42”) (42-49”)

PRODUCT # TEM-S TEM-M TEM-L

COLOR

CODE

1. Sling has two sides, the white fabric indicates the side that is intended to be next to the patient and the label and colored handles are on the outside. The bottom of the sling has two long straps and the inside of the sling has a padded waist section with a belt.

Whenever possible, have someone assist you to ensure the patient's safety at all times.

2. Lean patient forwards in the chair and make sure the patient is supported.

3. With the white fabric of the sling facing the patient, place the sling approximately halfway down the back, or so it is below the shoulder blades. Lean the patient against the back of the chair.

26

4. Fold the padded fabric waistband with the belt attached across the mid-section of the patient and clip the belt closed. Make sure the belt is secure.

ERGOFIT SLINGS

5. Tighten the belt until snug by pulling gently on the end of it.

8. Repeat step 7 with the other side.

6. Kneel in front of the patient so that your back is straight and so you are at eye level with the patient. Grab the end of the sling with the white fabric and make sure there are no twists in the sling. The white fabric should be facing the patient’s leg. Place the patient’s foot on your thigh and slide the white section of the sling under the leg.

9. Note that with the walking sling, the arms of the patient are always over top of the sling.

Sling attachment to Spreader bar

1. Ensure the sling is properly placed around the patient according to the instructions above.

2. Adjusting the sling loops higher or lower in either the front or the back allows you to tilt the body either direction to correct posture.

7. The straps that come from between the legs do not attach to the lift. Thread the strap at the chest through the longest loop on the same side.

27

Always use the same color loop on the rear shoulder straps for both sides of the sling.

Use the same color loop on the chest straps for both sides of the sling.

3. Make sure the patient’s arms are over top of the sling and that it is not caught on any obstructions (wheelchair brake or handle).

4. See ”Operation” section for next step.

5. When raising the patient in the lift, check to make sure the sling sections between the legs are providing snug support. If there is not enough support, reinstall the sling threading the chest straps through a lower loop (grey or black).

Repeat this step until the lower portion of the sling is provides proper support.

ERGOFIT SLINGS

28