Wireless repeater. Lupus Electronics LUPUSEC-XT1

Wireless repeater

You can connect a maximum of 20 sensors to the LUPUSEC XT1. If the range of one or more sensors is insufficient, you can increase this range with the wireless repeater. You can almost double the transmission range with a repeater, because the sensors are sending their signals first to the repeater and then the repeater relays these signals to the control unit. The wireless repeater is not a sensor and therefore not listed in the sensor list.

The repeater works on the 868.6625 MHz frequency and can amplify only sensors within this frequency range. The repeater does not support the PIR network camera, temperature sensors, wireless sockets, and in-wall relays.

5

7

U

G

S

TA

R

P

O

W

E

2

3

4 6

8

1

1.

Green LED: status indicator



On = Standby



Off = Off



Flashing = low battery

2.

Red LED: signal transmission



On = A signal is transmitted or received



Flashing = incorrect switch setting

3.

9 V DC 500 mA power supply connection

4.

Cover

5.

Mount

6.

Battery switch ON/OFF

7.

Buzzer

8.

Delete memory button

Note:

We strongly recommend installing the repeater at a minimum distance of 20 meters from the control unit to avoid signal interference.

107