Two-way motion detector. Lupus Electronics LUPUSEC-XT1

Two-way motion detector

Product description:

The two-way motion detector prevents false alarms caused by the double motion detection – PIR and microwave detection. The control unit triggers alarms only, if both methods detect a motion.

The PIR/microwave motion detector consists of a front a back. The mainboard to adjust various settings/adjustments is located on the front. You can mount the back either to flat surfaces or in corners by means of one of the two provided mounts.

Open the sensor by pressing a tool (e.g. a screwdriver) into the plastic notch at the bottom.

Sensor data:

Dimensions (without mount)

Weight:

Operating location:

Operating temperatures:

Humidity:

Microwave frequency:

Alarm system frequency:

6.33 x 11.25 x 6.2 cm

141 grams

Exclusively indoors

-

10 °C to 45 °C

Maximum 95 % (without condensed water)

10.525 GHz

868.6375 MHz

1.

IR motion detection LED (green)

The LED lights up with every motion detected by the IR sensor in test mode.

2.

Microwave detection LED (blue)

The LED lights up with every motion detected by the microwave sensor in test mode.

3.

Transmitter LED (red)

Lights up upon signal transmission in test mode.

4.

Sensor

5.

Tamper contact

6.

JP 1

Jumper 1 is reserved.

124

7.

Activate/deactivate supervisor Jumper Switch (JP2)

Jumper On

The jumper bridges the two pins.

Jumper Off

The jumper is removed or is on one pin only.

The supervisor mode is deactivated with Jumper 2 set to ON.

The supervisor mode is activated with Jumper 2 set to OFF (default setting).

8.

Activate/deactivate microwave test Jumper Switch (JP3)



The PIR/microwave sensor is in microwave test mode with Jumper 3 set to ON

(see Microwave test mode below).



The microwave test mode is deactivated with Jumper 3 set to OFF (default

setting).

9.

Learn/Test button

Press this button to add the PIR/microwave sensor to the control unit or to start the three-minute test mode.

10.

Battery compartment

A 3 V Lithium battery is required – model 1 CR123A.

11. Microwave range button

The arrow indicates the set range:



Turn the arrow clockwise to increase the detection range

(maximum 0-15 m)



Turn the arrow counter clockwise to reduce the detection range (minimum 0-5 m)



The default setting is minimum.

12.

Tamper contact

The tamper contact is pressed against the bump on the back and thus closed.

13.

Installation notch / break-joint

Standby mode

After every motion detection, the PIR/microwave sensor goes into the standby mode to save energy. Any other motion detection during this time resets the standby timer to one minute.

Supervisor function:

With Jumper 2 activated and the PIR/microwave sensor in normal mode, the supervisor signal is transmitted every 30 to 50 minutes. If the control unit does not receive the supervisor signal from the sensor, this causes the control unit to show an error message “Out of operation”.

Tamper contact

The tamper contact presses onto the mount on the back. With the PIR/microwave motion detector properly mounted, the tamper contact is closed in normal operation.

As soon as the tamper contact opens, the sensor transmits the tamper alarm to the control unit and the Transmitter LED lights up.

Break joint

125