LED/Beeper Indications & Controls. Magellan 2300HS, 2200VS

Appendix A

LED/Beeper Indications &

Controls

Speaker

Scan

Window

Indicator

LED plus

Volume/Tone

Push Button

Figure A-1

shows the operator’s controls and indicators for both models.

The descriptions following identify the use or function of each component.

Figure A-1. Scanner Controls and Indicators

Model 2200VS

Upper Scan

Window

Indicator LED

Volume/Tone

Push Button

Lower Scan

Window

Top Cover

Model 2300HS

A-377

Product Reference Guide

Volume/Tone Push Button

The Volume/Tone Push Button also performs multiple functions depending upon the duration of time it is pressed:

Volume changes made using the Volume/Tone Push Button are lost when the scanner is powered-down and are reset to the configured setting. If you wish to permanently change the volume, use the special programming labels in the Product Reference Guide.

NOTE

Table A-1. Volume/Tone Push Button Functions

PRESS

DURATION

FUNCTION

Momentary (when scanner is asleep)

Momentary (when scanner is awake)

Hold, then release when the beeper sounds

4 Seconds

8 Seconds

COMMENT

Wakes scanner from Sleep

Mode

Increments volume

Increments tone

Scanner Diagnostics Mode a

Resets Scanner b

Alternatively, the scanner can be awakened by:



- Moving an object through the scan zone.



- Scanning with an attached auxiliary scanner.

Press the push button momentarily to increase speaker volume. When the loudest volume is reached, a repeated press of the push button cycles volume back to the lowest setting, then volume increases on subsequent press(es). Four volume levels are available.

Press the push button for approximately 2 seconds, then release. Each time this is done, the beeper will sound at one of three tones. Stop when the desired tone (high, medium or low) is sounded.

This mode allows system support personnel to troubleshoot problems with the scanner and is used to determine if it can read bar codes. Press the button for eight seconds or cycle power to exit Scanner Diagnostics

Mode and reset the scanner.

Only system support personnel should perform a reset.

a. By standard default, this function is normally disabled to prevent accidental activation by users.

b. Users should not perform scanner resets except under the direction of trained systems support personnel.

A-378

Magellan

TM

2200VS/2200VS and 2300HS/2300HS

Green LED Indicator

The green LED indicates scanner status as shown in the table below.

Table A-2. Green LED Indications

LED

INDICATION

Scanner Active a

DURATION COMMENT

Scanner (Green) LED on steady and dim

The scanner is ready for operation. Scanning is immediately available.

(Normal Mode)

Good Read

Indication

a

Scanner (Green) LED - bright flash

Indicates a bar code has been read and decoded.

Program Mode

Indication



Scanner (Green) LED - Continuous flashing

Indicates the scanner is in Label Programming

Mode. Cycle power to exit Programming Mode.

Sleep Mode

Indication

Host Disabled

Scanner (Green) LED flashes slowly

The scanner motor and/or laser have automatically switched off and the unit has entered Sleep

Mode due to extended inactivity.

Scanner (Green) LED 1-second off, 1/

10-second on Host has disabled scanning.

Field Replaceable Unit (FRU)

Warning (Error

Mode)

Audible low tone 1 second. LED flashes continuously.

Serves notice that a fatal FRU failure has been detected. Call systems support for service.

FRU Indication

Scanner (Green) LED flashes a coded sequence in concert with the speaker.

Occurs ONLY upon Volume/Tone button push following a FRU warning. Enables service technicians to identify FRU failures.

a. Certain functions of the LED is selectable to be enabled or disabled. Your scanner may not be programmed to display all indications.

Product Reference Guide

A-379

NOTES

A-380

Magellan

TM

2200VS/2200VS and 2300HS/2300HS