Volume/Tone Push Button. Magellan 2300HS, 2200VS

Volume/Tone Push Button

The Volume/Tone Push Button also performs multiple functions depending upon the duration of time it is pressed:

Volume changes made using the Volume/Tone Push Button are lost when the scanner is powered-down and are reset to the configured setting. If you wish to permanently change the volume, use the special programming labels in the Product Reference Guide.

NOTE

Table A-1. Volume/Tone Push Button Functions

PRESS

DURATION

FUNCTION

Momentary (when scanner is asleep)

Momentary (when scanner is awake)

Hold, then release when the beeper sounds

4 Seconds

8 Seconds

COMMENT

Wakes scanner from Sleep

Mode

Increments volume

Increments tone

Scanner Diagnostics Mode a

Resets Scanner b

Alternatively, the scanner can be awakened by:



- Moving an object through the scan zone.



- Scanning with an attached auxiliary scanner.

Press the push button momentarily to increase speaker volume. When the loudest volume is reached, a repeated press of the push button cycles volume back to the lowest setting, then volume increases on subsequent press(es). Four volume levels are available.

Press the push button for approximately 2 seconds, then release. Each time this is done, the beeper will sound at one of three tones. Stop when the desired tone (high, medium or low) is sounded.

This mode allows system support personnel to troubleshoot problems with the scanner and is used to determine if it can read bar codes. Press the button for eight seconds or cycle power to exit Scanner Diagnostics

Mode and reset the scanner.

Only system support personnel should perform a reset.

a. By standard default, this function is normally disabled to prevent accidental activation by users.

b. Users should not perform scanner resets except under the direction of trained systems support personnel.

A-378

Magellan

2200VS/2200VS and 2300HS/2300HS