advertisement
Error Display
Menu Screen
Status Screen
Thumbnail Screen
EXT-RECORDER
POWER ?
^
VIDEO FORMAT
INCORRECT
MEDIA FULL
FAN MAINTENANCE
REQUIRED
^
^
^
Status Action
Power of the camera recorder is turned off while the external device connection is detected, and the same connection cannot be detected several seconds after power is turned on again. (Error displays for about 7 seconds)
● Video format of the file for Clip
Review is different from the [Frame
& Bit Rate] setting of the camera recorder.
● IEEE1394 input video format is different from the [Camera
Resolution] and [Frame & Bit Rate] settings.
● The video system of the camera recorder is not compatible with the
IEEE1394 input signal.
● [REC] button is pressed when the media in use has no remaining space.
● Remaining space ran out during recording.
● Usage time of the fan has exceeded 9000 hours.
When making use of a connected external device, turn on the power supply on the connected device.
Set [Camera Resolution] and [Frame & Bit
Rate] correctly. (A Page 75)
Set [System Definition] in the [Record
Format] menu according to the IEEE1394 signal. (A Page 75)
Replace the SDHC card with a new one.
Check the fan and replace accordingly. For more details, consult your nearest JVC dealer.
Memo :
● You can check the usage time of the fan in the [Others] menu B [System Information]
B [Fan Hour]. (A Page 95)
Tally Lamps
The tally lamps start blinking when the remaining space on the SDHC card is running out during recording, or when the battery power is running low.
Blinking Mode
Blinks slowly
(once every second)
Blinks quickly
(4 times a second)
Remaining Battery Power/SDHC Card Space
● Battery power is low
● Remaining recording time on SDHC card is less than 3 minutes
● SDHC card is full
● Error on the camera recorder
Alarm Tone
Alarm tone is output from the monitor speaker and [PHONES] terminal when the battery level is low.
Alarm tone is output from the monitor speaker and [PHONES] terminal when the SDHC card is full. (Camera mode only)
Alarm tone is also output when an error occurs in the camera recorder.
Memo :
● [Alarm Level] in the [Others] menu can be used to specify whether alarm tone is to be output, as well as the volume level.
(A Page 93)
● Alarm tone is not output during recording.
129
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- 1280 × 720p video recording at 60 frames per second
- 1/3-inch CMOS sensor
- Built-in microphone and speaker
- Variety of input and output ports
- Compact and lightweight design