Power supply connection. DAB EVOSTA 2

ENGLISH

9.1

Power supply connection

Phase

Action

EVOSTA3

1

Unscrew the cable gland nut and extract the terminal board from the connector, releasing it from the side clips.

2

Rotate the terminal board through 180°.

3

Fit nut and connector on the cable.

Strip the wires as indicated in the figure. Connect the wires to the terminal board, respecting the phase, neutral and earth

Illustration

Phase

Action

4

Insert the wired terminal board in the cable gland, securing it with the side clips. Screw on the locking nut.

5

Connect the wired connector to the pump, securing it with the rear hook.

Illustration

Table 4: Mounting the Evosta3 connector

41