Deconfiguring a HyperFabric Adapter with SAM. HP HyperFabric

Configuring HyperFabric

Deconfiguring a HyperFabric Adapter with SAM

NOTE

Deconfiguring a HyperFabric Adapter with

SAM

To use SAM to deconfigure a HyperFabric adapter on an HP 9000 system running HP-UX 11i v2, complete the following steps:

Step 1. Start SAM.

Step 2. Select the “Networking and Communications” area.

Step 3. Select “HyperFabric.”

All HyperFabric adapters installed in the system are listed. Installed adapters that are configured show Configured in the “Status” field, and installed adapters that are not yet configured show Not Configured in the “Status” field. You can deconfigure only an adapter with a status of

Configured.

Step 4. Highlight the adapter you want to deconfigure.

Step 5. Pull down the “Actions” menu and select Deconfigure Adapter.

Step 6. In the pop-up window, if you want to deconfigure the adapter, select OK to confirm it.

If you do not want to deconfigure the adapter, select Cancel.

Step 7. If you selected OK, the entry for the adapter is deleted from the

HyperFabric configuration files (/etc/rc.config.d/clic_global_conf and /etc/rc.config.d/netconf).

If you selected Cancel, you remain in the main “HyperFabric

Configuration” screen.

Step 8. Exit SAM.

If you have configured HMP for Transparent Local Failover support and if you select Deconfigure Adapter, HyperFabric will verify if the selected adapter is configured to be part of any card pair. If yes, the user

Chapter 4 83

Configuring HyperFabric

Deconfiguring a HyperFabric Adapter with SAM is informed and the card pair entry is removed from the

/etc/rc.config.d/netconf and

/etc/rc.config.d/clic_global_conf files.

84 Chapter 4