Chapter 6

Troubleshooting HyperFabric

Replacing a HyperFabric Switch

Replacing a HyperFabric Switch

If you need to replace a faulty HyperFabric switch, follow these steps:

Step 1. If you do not have an HA environment, stop HyperFabric on all nodes

that are connected to the faulty switch. (See “Stopping HyperFabric” on page 128.)

If you have an HA environment with two switches (where the backup switch will have taken over when the first switch failed), disconnect all cables attached to the faulty switch.

Step 2. Install a new switch. (See “Installing HyperFabric Switches” on page 57.)

Step 3. If you stopped HyperFabric on all nodes connected to the switch (in step

1), start it on those nodes. (See “Starting HyperFabric” on page 109.)

157

Troubleshooting HyperFabric

Replacing a HyperFabric Switch

158 Chapter 6

A Safety and Regulatory

Information

Appendix A

This appendix contains the following sections that contain safety information and regulatory statements for the HyperFabric hardware

159

Safety and Regulatory Information components:

•

“Safety Symbols” on page 161.

•

“Regulatory Statements” on page 162.

These components were tested for conformance to various national and international regulations and standards. The scope of this regulatory testing includes electrical and mechanical safety, electromagnetic emissions, immunity, acoustics, and hazardous materials.

When required, approvals are obtained from third party test agencies.

Approval marks appear on the product label. In addition, various regulatory bodies require some information under the headings noted below.

160 Appendix A