advertisement
4 WEB CONFIGURATION
The PoE Injector Hub provide Web interface for PoE smart function configuration and make the PoE Injector Hub operate more effectively - They can be configured through the Web Browser. A network administrator can manage and monitor the
PoE Injector Hub from the local LAN. This section indicates how to configure the PoE Injector Hub to enable its smart function.
The following screen based on POE-2400P4, for POE-1200 / POE-1200P2 / POE-2400 the display will be the same to POE-2400P4.
4.1 Manin Menu
After a successful login, the main screen appears. The main screen displays the product name the function menu, and the main information in the center. As showed in Figure 4-1 .
Figure 4-1
Web Main Menu screen
The four items and it description shown as below:
System: Provide System information of PoE Injector Hub.
Explained in section 4.3.
PoE Configuration : Provide PoE Management configuration of PoE Injector Hub. Explained in section 4.4.
Tools: of PoE Injector Hub. Explained in section 4.5.
Logout: Provide Logout function of PoE Injector Hub. Explained in section 4.6.
15
4.2 Web Panel
At the top of the Web management page, the active panel displays the link status of management port and PoE ports.
Figure 4-2 Web panel screen
Green lit is the network data send or receiver,
Orange lit is the PoE in use.
4.3 System
The System function allows viewing system information, IP Configuration and Password Setting. As showed in Figure 4-3 .
Figure 4-3
System screen
The page includes the following information:
Object Description
System Information
Display the MAC address, Software Version, Hardware Version, IP Address, Subnet Mask,
Gateway and Description.
Explained in section 4.3.1.
IP Configuration Allow to change the IP subnet address of PoE Injector Hub. Explained in section 4.3.2.
Password Setting Allow to change the username and password of PoE Injector Hub. Explained in section 4.3.3.
16
advertisement
Related manuals
advertisement
Table of contents
- 4 1. INTRODUCTION
- 8 2. INSTALLATION
- 8 2.1.1 Injector Front Panel
- 9 2.1.2 LED Indicators
- 10 2.1.3 Injector Rear Panel
- 10 2.2.1 Desktop Installation
- 11 2.2.2 Rack Mounting
- 12 2.2.3 Network Application Installation
- 13 2.2.4 Power over Ethernet Powered Device
- 14 3 MANAGEMENT
- 14 3.3.1 Web Management
- 16 3.3.2 PLANET Smart Discovery Utility
- 18 4 WEB CONFIGURATION
- 20 4.3.1 System Information
- 21 4.3.2 IP Configuration
- 22 4.3.3 Password Setting
- 26 4.5.1 Firmware Upgrade
- 28 4.5.2 Configuration Setting
- 30 4.5.3 Configuration Backup
- 34 4.5.4 Alert Trap Configuration
- 35 4.5.5 System Reboot
- 36 5. POWER OVER ETHERNET OVERVIEW
- 38 6. THE POE PROVISION PROCESS
- 40 7 TROUBLESHOOTING
- 41 APPENDIX A
- 43 APPENDIX B