Configuring the PC Software Browser for OpenCTI and OpenHotel
Requirements
To use the systray display, you must first install TAPI; see Setting up TAPI starting on page 160.
Please note: The systray display requires a current version of TAPI. If you are using TAPI from an earlier version of the OpenCom 100, you must first install the newer version from the product CD.
Installing the systray display
1. Call up the start mask of the product CD (see Configuring the PC Software on page 158).
2. From the start mask, select Software: Install Systray. Follow the program instructions.
3. Start the program with Start: Run and the configuration dialogue is displayed.
Select one of the entries displayed under Existing PBXs. Enter your user name and password in the boxes under Log-on.
4. If you activate the Autostart check box, you will see the systray display even after restarting your PC.
5. Confirm the entries in the configuration dialogue with OK and the systray display logs on for the OpenCom 100.
6. Right-click on the systray display in the Start bar. Select Configu-
ration to call up the configuration dialogue. Select Network Con-
nections or Trunk Lines to produce a status dialogue.
16.5
Browser for OpenCTI and OpenHotel
You can simplify the daily use of the OpenCTI and OpenHotel Web applications using the Web browser especially adapted for the OpenCom 100. Each time the workstation is restarted, this browser program can automatically start and log you in. This means that the applications are always operational and can be accessed using the icon in the information area of the task bar.
164
