Configuration Configuring the OpenCom 510
8.2
Configuring the OpenCom 510
8.2.1 Preparing the Configuration
Before starting with the configuration, make sure you have the following documents at hand:
■ An overview of the ports
■ A list of the terminals to be connected
■ A list of the IPEIs, if you wish to log on DECT terminals in the secure procedure
■ A list of the users to be set up (staff entitled to use the services of the
OpenCom 510) with their names, departments, and the internal call numbers you want to allocate to them
■ For Internet access: the Internet service provider access data.
Data not available for initial configuration can be updated or corrected at a later date.
Note: Use the
Configuration Guide starting on page 192. This
will assist you in making the settings in the correct sequence.
8.2.2 Starting the Web Console
1.
Start your Web browser. Enter the OpenCom 510 IP address in the “Address” box: http://192.168.99.254/.
If the configuration PC gets its IP address automatically from the OpenCom 510 or if the OpenCom 510 is entered as the domain name server, you can also start the Web console by entering the DNS name. The DNS name in the factory setting is host.domain
. You can change this in the Configurator ( NET Configuration: LAN menu).
2.
The OpenCom 510 Web console is started. First set the country in which you are operating the OpenCom 510, and in which language the Web console is to be displayed.
85
Configuration Configuring the OpenCom 510
OpenCom 510: log-on dialogue box
3.
To commence configuration, you must first log on. For the initial configuration, enter your:
- user name: “Administrator”
- password: for the initial configuration, leave this box blank.
4.
Confirm this by clicking on OK . This puts all connected terminals into the
“Guest” user group with restricted user rights. In this way you prevent international external calls from the terminals, for example, while you are configuring the OpenCom 510 and the users.
OpenCom 510: dialogue box for initial access
86
