Voice over IP (VoIP) SIP Telephony in the Configurator
in the Web console (see also Installing Interface Cards starting on page 31).
Each MG+ETH1-1 interface card requires its own IP address. This can either be assigned statically or obtained via DHCP.
1.
In the Configurator , open the PBX Configuration: Ports: Slots page.
2.
Click on the slot number in the table row containing the desired interface card.
3.
Enter the desired IP address in the IP address configured field. Enter “0.0.0.0” to obtain an IP address via DHCP.
4.
Confirm with Apply .
The configuration page displays the MG+ETH1-1 interface card’s MAC address. You will need this for the static assignment of an IP address via a DHCP server.
10.4
SIP Telephony
The SIP Internet (Session Initiation Protocol) protocol provides you with a low-cost, standardised option for telephoning via IP-based networks. OpenCom 510 enables you to use external SIP telephone connections (“SIP trunk lines”).Furthermore, internal SIP subscribers, SIP telephones or SIP telephony software are also supported.
10.4.1 External SIP connections
The PBX Configuration : Trunks : Route menu gives you the option of making an
SIP connection on a normal ISDN line in case of bundle overflow, breakdown or over-occupancy. You can also set up your system to route certain types of calls, such as international calls, to an SIP connection.
Note: You will need a Media Gateway card for SIP telephony.
You will also need a fast Internet connection such as DSL for SIP telephony.
You will also usually need the services of a SIP provider. A SIP provider operates a special server (the SIP Registrar) to handle connections. The SIP provider also operates a gateway to the ordinary telephone network which users pay to use and
117
Voice over IP (VoIP) SIP Telephony which enables the SIP provider to provide calls to the telephone network.A SIP connection can also accept incoming calls from the telephone network.
The same voice transmission techniques as those explained in
Fundamentals starting on page 110 are used for SIP telephony. SIP telephony has the following
distinctive features:
■ Subscribers are identified through an e-mail-like “SIP ID” such as
[email protected] or [email protected].
■ SIP transmits dialling numbers always in a single data package (block dialling).
Dialling can therefore be concluded with the hash key # on the system terminal, or the end of the number will be indicated by a time-out. The value for this time-out can be defined for each SIP provider separately.
■ You must log on (“Login”) to the SIP registrar before you can use SIP telephony.
Use the OpenCom 510 to manage important information for the registration
(user name and password) of one or more SIP accounts. It is possible to make several calls simultaneously using a single SIP account.
■ A SIP connection causes constant Internet data traffic, so do not use SIP with
Internet access which is paid for according to the time used.
■ RTP call data is also exchanged directly between terminals for SIP telephony, so different codecs can be used for sending and for receiving. It is also possible to change codecs dynamically during a call. You should use every codec available in the VoIP profile at least once, because this will enable you to establish connections with as many SIP subscribers as possible.
■ Fairly large packet lengths are quite normal on the Internet. They compensate for the longer packet propagation delay.
■ A bidirectional RTP data stream with a dynamically-assigned UDP port number is used to set up calls between subscribers. For this reason, incoming RTP calls often fail to get past the Firewall or NAT configuration of the Internet gateway product used. Do not use OpenCom 510 as an Internet gateway if the product used is to be compatible with SIP telephony. These products provide a “Full
Cone NAT” setting for this application.
■ To enable the use of multiple devices on a single Internet connection, the IP addresses used in a LAN (often 192.168.x.x) are translated to a valid IP address using address translation (NAT - Network Address Translation), but no status
118
