Technical Data
20. Technical Data
Please observe the technical information regarding modules under
Modules starting on page 59.
Component
1-12 frame of the OpenCom 510
Page
– BPV+1-12 backplane system: Supply voltages and system signals for up to 2 power supply units, 1 central control module and 12 interface cards
– Dimensions:
35
– 4.5 height units (1 U = 44.45 mm)
19" frame in accordance with DIN
41494 Part 5 for installation in a 19" cabinet
27
– Number of slots:
Modules
12
– MPS+1-AC power supply unit (with AC/DC converter)
– MC+1-3 central control module
–
–
MT+S2M1-1 trunk module
MX+S01-8 subscriber or trunk module
– MT+A1-4 trunk module
– MS+UPN1-8 subscriber module
62
65
68
71
–
–
MS+UPN2-8 subscriber module
MS+A1-8 subscriber module
– MG+ETH1-1 media gateway module for VoIP
80
73
76
78
115
209
Technical Data
The following table provides an overview of the configuration limits for the
OpenCom 510. These limits result from the combination of different interface cards.
OpenCom 510: system configuration limits (single 19" frame)
Interface card
(module) maximal insertable
Maximum number of interfaces
Note
MC+1-3 1
MT+S2M1-1
MX+S01-8
MS+UPN1-8
MS+UPN2-8
4
12
11
11
4 x S
2M
96 x S
0
88 x U pn
(10/100 Mbits/s), 1 x V.24
–
(for internal or external use)
– with a single 19" frame (a total of 12 slots) one slot is required for the outside line
– with a cascaded system
(two 19" frames) 12 interface cards of this type can be inserted in the 19" frame of the slave system
88 x U pn
– U pn
interfaces are
DECT-capable
– with a single 19" frame (a total of 12 slots) one slot is required for the outside line
– with a cascaded system
(two 19" frames) these interface cards can only be inserted in the 19" frame of the master system
210
Technical Data
OpenCom 510: system configuration limits (single 19" frame)
Interface card
(module)
MS+A1-8 maximal insertable
11
Maximum number of interfaces
88 x a/b
Note
MT+A1-4
MG+ETH1-1
12
4
48
– with a single 19" frame (a total of 12 slots) one slot is required for the outside line
– with a cascaded system
(two 19" frames) 12 interface cards of this type can be inserted in the 19" frame of the slave system for analogue trunk lines
(10/100 Mbits/s)
– with a cascaded system
(two 19" frames) 12 interface cards of this type can be inserted in the 19" frame of the master system
System configuration limits in general
CompactFlash carte
1 – –
Note: The online help provides an overview of the limits that should be observed when configuring the
OpenCom 510.
211
