advertisement
GB
CY
5) Place your selected cutting disc 9 into the meat grinder casing 5 so that the fi xings on the cutting disc 9 are located in the openings in the meat grinder casing 5 .
6) After everything has been correctly assembled, screw the ring clamp 0 back on hand-tight.
7) The ready-assembled meat grinder casing 5 is connected by a bayonet connector to the motor block 4 :
– Insert the meat grinder casing 5 into the motor block 4 such that the arrow on the meat grinder casing 5 lies against the symbol on the motor unit 4 . The locking button presses itself in (Fig. B).
– Lightly press the meat grinder casing 5 in and at the same time turn the feeding shaft on the meat grinder casing 5 into the middle position
(Fig. B) so that the arrow on the feeding shaft points to the symbol .
When the meat grinder casing 5 engages, the locking button springs out.
– Finally, place the feeding tray 3 on top of the feeding funnel.
– To dismantle it, press the locking button and turn the feeding funnel to the right (Fig. B) . You can now pull the meat grinder casing 5 out.
Assembling the sausage stuff er attachment
Unfold the fold-out side - there you will fi nd the step-by-step illustrations for assembling the appliance.
1) Remove the meat grinder casing 5 as described under “Assembling the meat grinder”.
2) Disassemble any attachments that might be fi tted and clean the meat grinder casing 5 .
NOTICE
► For the sausage stuff er attachment q , the cross blade 8 with the spring 7 is not required! If need be, remove them both from the meat grinder casing 5 .
3) Coat all metal parts with cooking oil.
4) Insert the sausage disc w so that the fi xings on the sausage disc w are located in the openings in the meat grinder casing 5 .
5) Then place the sausage stuff er attachment q before the sausage disc w .
6) Screw the ring clamp 0 on hand-tight.
7) Assemble the meat grinder casing 5 as described under “Assembling the meat grinder”.
6
SFW 350 C1
advertisement