Displaying/Resetting Minimum Value Storage for Indoor Temperature. Eurochron EC-4406172

 Displaying/Resetting Minimum Value Storage for Indoor Temperature

• Touch the display area “IN TEMP” repeatedly until the indoor temperature minimum and the display “MIN” (to the left of the weather symbols) flash.

• To reset the minimum value storage, keep the display area “IN TEMP” pushed for 3 seconds. The new minimum is the currently measured indoor temperature until it changes.

To get back to the first subfunction (select the temperature unit) -> touch the display area “IN TEMP” briefly 2x

Leaving setting mode -> touch the button “IN TEMP” briefly 1x (or touch another display area wait for 30 seconds without touching the touch screen)

i) Display Area “IN HUMIDITY” (indoor humidity)

The following setting and subfunctions are available:

• Setting and Activating/Deactivating Upper Humidity Alarm

• Setting and Activating/Deactivating Lower Humidity Alarm

• Displaying/Resetting Maximum Value Storage for Indoor Humidity

• Displaying/Resetting Minimum Value Storage for Indoor Humidity

Touch the display area “IN HUMIDITY” briefly repeatedly until the desired subfunction flashes.

Setting and Activating/Deactivating Upper Indoor Humidity Alarm

• Touch the display area “IN HUMIDITY” repeatedly until the indoor humidity and the display “HI AL” flashes.

• Select the upper threshold of the indoor humidity with the buttons “+” and “-”. Keep the respective button pressed for quick adjustment.

• Use the button “ON/OFF” to switch the alarm function on or off.

With the alarm function on, the icon “ ” appears below the display “HI AL”. When the threshold value set is exceeded, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display

“HI AL” and the icon “ ” continue to flash, however, until the measured value drops below the threshold value set.

To get to the next subfunction (setting and activating/deactivating the lower humidity alarm) -> touch the display area “IN HUMIDITY” briefly

Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch screen)