Displaying/Resetting Maximum Value Storage for Outdoor Humidity. Eurochron EC-4406172

 Displaying/Resetting Maximum Value Storage for Outdoor Humidity

• Touch the display area “OUT HUMIDITY” repeatedly until the outdoor humidity and the display “MAX” (to the left of the weather symbols) flash.

• To reset the maximum value storage, keep the display area “OUT HUMIDITY” pushed for 3 seconds. The new maximum is the currently measured outdoor humidity until it changes.

To get to the next subfunction (displaying/resetting the minimum value storage for outdoor humidity) -> touch the display area “OUT HUMIDITY” briefly

Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch screen)

 Displaying/Resetting Minimum Value Storage for Outdoor Humidity

• Touch the display area “OUT HUMIDITY” repeatedly until the outdoor humidity minimum and the display “MIN” (to the left of the weather symbols) flash.

• To reset the minimum value storage, keep the display area “OUT HUMIDITY” pushed for 3 seconds. The new minimum is the currently measured outdoor humidity until it changes.

To get back to the first subfunction (setting and activating/deactivating the upper humidity alarm) -> touch the display area “OUT HUMIDITY” briefly 2x

Leaving setting mode -> touch the button “OUT HUMIDITY” briefly 1x (or touch another display area wait for 30 seconds without touching the touch screen)

l) Viewing or Deleting Measured Data

View stored measured data/measured values:

• Touch the display area “MEMORY” in the lower right of the display once. The buttons “+” and “-” flash.

• You can use the two buttons “+” and “-” to display the measured values now.

The display shows the respective time and date of the measured value dataset.

In the basic setting, a dataset is stored every 30 minutes. This can be adjusted by PC software.

The display mode is left automatically if the touch screen is not touched for approx. 30 seconds.

Delete all stored measured data/measured values:

• Touch the display area “MEMORY” 2x.

The display area “MEMORY” flashes and the message “CLEAR” appears in the area of the data display at the bottom.

• To delete all measured values that were saved, keep the display area “MEMORY” pushed for 3 seconds. The memory display stops flashing; the data are deleted.

If you do not want to delete the data, either touch any other display area or wait for 30 seconds without touching the touch screen.