Radio. Alpine X800D-S906, X800D-V447, X800D-, X800D-V

Radio

Display example for Radio main screen

Presetting Stations Manually

1

Tune in a desired radio station you wish to store in the preset memory by manual or automatic seek tuning.

2

Touch and hold any one of the preset buttons for at least 2 seconds.

The selected station is stored.

3

Repeat the procedure to store up to 5 other stations onto the same band.

To use this procedure for other bands, simply select the desired band and repeat the procedure.

A total of 30 stations can be stored in the preset memory

(6 stations for each band; FM1, FM2, FM3, MW or LW).

• If a preset memory has already been set in the same preset number, it will be cleared and the new station will be memorised.

Touch [ ], [ ]

Band display

Frequency display

Preset button

SEEK mode

Listening to the Radio

1

Press the button.

2

Touch [Radio] of Top banner.

The radio mode is activated and the display changes to the

Radio mode screen.

• The display content varies depending on the last band selected.

([RadioFM1], etc.)

3

Touch [Band] of Bottom banner to select the desired radio band.

Each touch changes the bands as follows:

Presetting Stations Automatically

The tuner can automatically seek and store 6 strong stations in the selected band in order of signal strength.

After selecting the desired band, touch [A.Memo] of

Bottom banner.

The tuner automatically seeks and stores 6 strong stations into the preset buttons in order of signal strength.

When automatic storing has completed, the station stored in the preset 1 is selected.

If [A.Memo] is not displayed, touch [ ] or [ ] in the bottom banner to display [A.Memo].

• If no stations are stored, the tuner will return to the original station you were listening to before the automatic storing procedure began.

• You can cancel this process by touching [A.Memo] while the tuner is automatically seeking stations. Cancelling will return the tuner preset to the previous setting.

4

Touch [TUNE] to select the tuning mode.

DX SEEK Local SEEK MANUAL PTY *

* Displays only when the PTY tuning mode is selected. For

details, refer to “PTY (Programme Type) Tuning” (page 34).

• There are two modes you can select for auto tuning, DX and

Local:

DX (Distance) mode;

Both strong and weak stations will be tuned in.

Local mode;

Only strong stations will be tuned in.

The initial setting is DX.

5

Touch [ ] , [ ] or [ ] , [ ] to change the radio frequency up or down respectively.

In manual mode, touch and hold to change the frequency continuously.

Tuning to Preset Stations

You can tune in the preset stations in memory on either band using its preset number.

1

Touch [Band] of Bottom banner repeatedly until the desired band is displayed.

2

Touch any one of the preset buttons that has a station stored to it.

The preset station is received.

32

-EN