advertisement
Connections
REMOTE TURN-ON
(Blue/White)
REVERSE
(Orange/White)
PARKING BRAKE
(Yellow/Blue)
IGNITION
(Red)
GND
(Black)
POWER ANT
(Blue)
BATTERY
(Yellow)
IPOD VIDEO
MIX CONT
(Green/White)
STEERING REMOTE
BEEP/NAVIRG
CAMERA1
(Not used for Benz M-Class.)
REMOTE OUT
(Brown)
REMOTE IN
(Brown)
SPEED SENSOR
(Green/White)
(Yellow)
(Red)
(White)
(Yellow)
(Red)
(White)
(Green)
(Green/Black)
(White)
(White/Black)
(Grey/Black)
(Grey)
(Violet/Black)
(Violet)
Antenna
ISO Antenna Plug
To external Audio Processor
(PXA-H800, etc,.)
To iPod Video Output terminal
To guide control input terminal
To steering remote control interface box
To Guide Input terminal
To Front/Rear camera
To Rear/Other/camera
To CAN Interface box
To remote input lead
To remote output lead
To the vehicle speed pulse line
To Video Output terminal
To Audio Output terminals
(R, L)
To Video Input terminal
To Audio Input terminals
(R, L)
Rear Left
Amplifier
Rear Right
Amplifier
Front Left
Front Right
Amplifier Subwoofers
To amplifier or equalizer
To plus side of the back lamp signal lead of the car
To the parking brake signal lead
To power antenna
Ignition key
Battery
Rear left
Front left
Front right
Speakers
Rear right
107
-EN
Radio Antenna Receptacle
ISO/JASO Antenna Adapter (sold separately)
ISO/JASO Antenna Adapter may be required, depending on the vehicle.
Digital Output Terminal (Optical)
Use when combining fiber optic digital input compatible products. Be sure to use the Optical Digital Cable
(KWE-610A) (sold separately) only.
iPod VIDEO Input Connector
Input the iPod/iPhone video signal or AUX video/audio signal.
•
Set “AUX3 In Sel.” (page 62) to “iPod Video” when an
iPod/iPhone is connected.
•
Set “AUX3 In Sel.” (page 62) to “AUX3” when AUX video/
audio is input.
MIX Control Lead (Green/White)
Use when an optional External Audio Processor with guide control input terminal is connected.
• When this lead is connected to PXA-H800, make sure to turn the ignition key off (ACC OFF) and on (ACC ON) again or turn the unit power off and on again, after setting
“Navi Mix” from OFF to ON on PXA-H800.
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine dealer.
Beep/NAVI Guide Connector
Output the audio signal of navigation interruption.
When connecting an Audio processor, connect this lead to the Guide Input terminal with an optional RCA Extension cable.
Direct CAMERA Input Connector
Use when the optional direct camera is connected.
CAMERA Input RCA Connector (Yellow)
Use when connecting a camera with RCA Output
Connector.
CAN Interface Connector (Not used for Benz
M-Class.)
To CAN Interface box.
• When both CAN Interface box and Vehicle Display
Interface box are connected to this unit, the operation may not be performed as normal.
Remote Control Output Lead (Brown)
Connect this lead to the remote control input lead. This lead outputs the controlling signals from the remote control.
Remote Control Input Lead (Brown)
Connect the external Alpine product to the remote control output lead.
Speed Sensor Lead (Green/White)
Improper connection of the speed pulse line may cause important safety features of the vehicle to fail (such as the brakes or air bags). Such failures may result in an accident and loss of life. We strongly recommend that the installation be performed by a trained, authorised Alpine dealer.
Video Input Connector (AUX INPUT) (Yellow)
Input the video.
Audio Input Connectors (AUX INPUT)
RED is right and WHITE is left input the audio.
Video Output Connector (AUX OUTPUT) (Yellow)
Output the video.
Audio Output Connectors (AUX OUTPUT)
RED is right and WHITE is left output the audio.
108
-EN
Rear Output RCA Connectors
It can be used as Rear Output RCA Connectors.
Front Output RCA Connectors
It can be used as Front Output RCA Connectors.
Subwoofer RCA Connectors
RCA Extension Cable (sold separately)
HDMI input Connector
Input HDMI signal, you should prepare an optional Alpine special HDMI cable.
USB Connector
To USB Memory or iPod/iPhone.
GPS antenna Receptacle
Connect to GPS antenna (included).
Vehicle Display Interface Connector
Outputs Vehicle Display Interface control signals. Connect this to the optional Vehicle Display Interface box.
For details about connections, consult your nearest Alpine dealer.
• When both CAN Interface box and Vehicle Display
Interface box are connected to this unit, the operation may not be performed as normal.
DAB Antenna Connector
To DAB Antenna (sold separately).
EXT KEY Connector
To external key panel.
AUX/PRE OUT Connector
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or signal processor.
Reverse Lead (Orange/White)
Connect to the plus side of the car’s reverse lamp. This lamp illuminates when the transmission is shifted into reverse (R).
With this lead properly wired, the video picture automatically switches to the rear camera whenever the car is put into reverse (R).
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the parking brake switch to transmit the parking brake status signals to the X800D.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
• This lead should be used only for controlling the vehicle’s power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
Fuse Holder (15A)
ISO Power Supply Connector
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Grey/Black)
Right Front (+) Speaker Output Lead (Grey)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
ISO Connector (Speaker Output)
CAMERA/W.REMOTE Connector
Power Supply Connector
109
-EN
advertisement
Related manuals
advertisement