Installation. Alpine X800D-S906, X800D-V447, X800D-, X800D-V

Installation

Caution

Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.

<example>

Air ventilation hole

Heat sink

Rear of the Unit

Caution concerning the installation location

Before installing, make sure that the opening and closing of the display will not interfere with operation of the gear shift.

Movable Display

Mounting the GPS Antenna inside the vehicle.

1 Clean the mounting location.

2 Put on the GPS Antenna mounting plate.

3 Mount the GPS Antenna.

GPS Antenna

Antenna mounting plate

• Mount the GPS Antenna on a flat plane of the dash board or rear tray.

• Some thermal reflection type or thermal absorption type glass may interrupt high frequency waves. If reception is poor with the antenna installed inside the car, try to mount the antenna outside the car.

• Make sure the GPS Antenna is not covered (obstructed) by any metallic surface or object.

Angle of installation

Install at an angle between horizontal and 30°. Note that installing at an angle outside of this range will result in a loss of performance and possibly damage.

0 - 3 0°

105

-EN

Connection Diagram of SPST Switch (sold separately)

(If the ACC power supply is not available)

X800D

ACC

(Red)

BATTERY

(Yellow)

SPST SW (Optional)

FUSE (5A)

(Optional)

FUSE (20A)

(Optional)

Battery

• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).

• The diagram and the fuse amperage shown above are in the case when X800D is used individually.

• If the switched power (ignition) lead of the X800D is connected directly to the positive (+) post of the vehicle ’ s battery, the

X800D draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the battery may be discharged.

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the car harness.

• Keep the battery power leads as far away from other leads as possible.

• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

106

-EN