Setup. IC Realtime NVR-8128K-DR

icons at the left top corner of the channel number for you reference. M stands for main stream. S stands for sub stream (extra stream).

4) If you login via the WAN mode, system does not support alarm activation to open the video function in the Alarm setup interface.

Important

 For multiple-channel monitor mode, system adopts extra stream to monitor by default. You can not modify manually. All channels are trying to synchronize. Please note the synchronization effect still depends on your network environments.

 For bandwidth consideration, system can not support monitor and playback at the same time.

System auto closes monitor or playback interface when you are searching setup in the configuration interface. It is to enhance search speed.

4.8 Setup

4.8.1 Camera

4.8.1.1 Remote Device

4.8.1.1.1 Remote Device

From main window->Setup->Camera->Remote device->Remote device, you can see remote device

interface is shown as below. See Figure 4-17.

Figure 4-17

126

Figure 4-18

Please refer to the following sheet for log parameter information.

Parameter Function

Device search

Add

Click Device search button, you can view the searched device information on the list. It includes device IP address, port, device name, manufacturer and type.

Select a device in the list and then click Add button, system can connect the device automatically and add it to the Added device list.

Or you can double click one item in the list to add a device.

Modify

Click or any device in the Added device list, you can change the corresponding channel setup.

Delete

Click , you can delete the remote connection of the corresponding

Connection status channel.

: Connection succeeded.

: Connection failed.

Delete Select a device in the Added device list and then click Delete button, system can disconnect the device and remove it from the Added device list.

127