Alarm. IC Realtime NVR-8128K-DR

Figure 4-61

4.8.3.4 Alarm

Before operation, please make sure you have properly connected alarm devices such as buzzer. The input mode includes local alarm, network alarm, and IPC external alarm and IPC offline alarm.

4.8.3.4.1 Local Alarm

From main menu->Setup->Event->Alarm->Local alarm, the local alarm interface is shown as in Figure

4-62. It refers to alarm from the local device.

159

Figure 4-62

Figure 4-63

160

Figure 4-64

Please refer to the following sheet for detailed information.

Parameter Function

Enable

Period

You need to check the box to enable this function.

Please select a channel from the dropdown list.

This function becomes activated in the specified periods.

There are six periods in one day. Please draw a circle to enable corresponding period.

Select date. If you do not select, current setup applies to today only. You can select all week column to apply to the whole week.

Click OK button, system goes back to local alarm interface, please click save button to exit.

Anti-dither

Sensor type

System only memorizes one event during the anti-dither period. The value ranges from 5s to 600s.

There are two options: NO/NC.

Record channel System auto activates motion detection channel(s) to record once an alarm occurs. Please note you need to set alarm record period and go to Storage-> Schedule to set current channel as schedule record.

161

Parameter

Record Delay

Alarm out

Latch

Show message

Buzzer

Alarm upload

Send Email

Function

System can delay the record for specified time after alarm ended. The value ranges from 10s to 300s.

Enable alarm activation function. You need to select alarm output port so that system can activate corresponding alarm device when an alarm occurs.

System can delay the alarm output for specified time after an alarm ended. The value ranges from 1s to 300s.

System can pop up a message to alarm you in the local host screen if you enabled this function.

Check the box here to enable this function. The buzzer beeps when an alarm occurs.

System can upload the alarm signal to the centre

(Including alarm centre).

If you enabled this function, System can send out an email to alert you when an alarm occurs.

Tour You need to click setup button to select tour channel.

System begins 1-wiindow or multiple-window tour display among the channel(s) you set to record when an alarm

occurs. See Figure 4-54.

PTZ Activation Here you can set PTZ movement when an alarm occurs.

Such as go to preset X. See Figure 4-64.

Snapshot

Click setup button to select snapshot channel. See Figure

4-55.

4.8.3.4.2 Net Alarm

From main menu->Setup->Event->Alarm->Net alarm, the network alarm interface is shown as in Figure

4-65.

Network alarm refers to the alarm signal from the network. System does not anti-dither and sensor type

setup. For setup information, please refer to chapter 4.8.3.4.1.

162

Figure 4-65

4.8.3.4.3 IPC external alarm

From main menu->Setup->Event->Alarm->IPC external alarm, the IPC external alarm interface is shown

as in Figure 4-66.

Network alarm refers to the alarm signal from the network. System does not support anti-dither and

sensor type setup. For setup information, please refer to chapter 4.8.3.4.1.

Figure 4-66

4.8.3.4.4 IPC Offline Alarm

From main menu->Setup->Event->Alarm->IPC offline alarm, the IPC offline alarm interface is shown as

163