Disconnecting Wi-Fi. Honeywell RTH6580, RTH6580WF, RTH6500WF Wi-Fi Series

Disconnecting Wi-Fi

Replacing your router

If you disconnect the thermostat from your Wi-Fi network:

1 Enter system setup (see page 48).

2 Change setting 39 to 0 (see page 54).

The screen will display

Wi-Fi Setup.

Re-connect to a Wi-Fi network by following the steps on page 26.

M33855

Turning Wi-Fi off

If you do not plan to control the thermostat remotely, you can remove the Wi-Fi Setup message from the screen:

1 Enter system setup (see page 48).

2 Change setting 38 to 0 (see page 54). Wi-Fi Setup will be removed from the screen.

If you want to connect to the Wi-Fi network later, change setting 38 back to 1.

43

69-2718EF—01

Software updates

Honeywell periodically issues updates to the software for this thermostat. The updates occur automatically through your Wi-Fi connection. All your settings are saved, so you will not need to make any changes after the update occurs.

While the update is taking place, your thermostat screen flashes Updating and shows the percentage of the update that has occurred. When the update is complete, your home screen will appear as usual.

Note:

If you are not connected to Wi-Fi, you will not get automatic updates.

69-2718EF—01

44

M34001

Percentage of update complete