Power Efficient Operation. BusLogic BT-XlO A
विज्ञापन
विज्ञापन
space available is always the capacity of the smaller of the pair of drives. Its operation is transparent to both the user and operating system. The maximum is two mirrored pairs per controller.
Linked drives. This feature lets you designate two HDDs as one logical drive whose capacity is the total of both hard drives. The maximum is two linked pairs per controller.
Mirroring and linking are configured using the BT-XlOA’s onboard menudriven AutoIDETM configuration utility. You can also use the AutoIDE to do the following:
Enable track-remapping for >528MB drive support under DOS environment
Access power saving and drive support options, cache line size, and other settings for the controller
Display drive information such as drive model, firmware version, serial number, and so forth
Perform low level formats
Initialize/repair mirroring pair drives
Verify that the mirroring pair has identical data
Copy and compare disk data from the source disk to the target disk
P
O W E R
E
FFICIENT
O
P E R A T I O N
The IDE Caching Controller also offers efficient system operation for both the IDE drive(s) and the board itself. When the board is idle, i.e., there is no access activity to the storage subsystem, the clock signal generated by the on-board processor is turned off automatically, forcing the remaining power-consuming components into the sleeping states. The resulting power saving is significant.
An option of the AutoIDE, Motor Off, configures the controller to turn off the IDE drive’s motor after a specific period of idle time. Refer to Green
Cache Mode in the AutoIDE’s Controller Option Select module (Section 4) for details.
I-2 I BT-XIOA IDE
Caching Controller
S
UPPORT FOR
4 D
R I V E S
The
IDE Caching Controller supports up to four independent drives, i.e., physical drives C:, D:, E:, and F:. Any of these drives can be designated the boot drive. If two controllers are installed, one as primary and the other as secondary, you can control up to eight individual drives. Refer to More
Than 2 Drives option in the AutoIDE’s Controller Option Select module
(Section 4) for details.
D
RIVER
S
U P P O R T
The
BT-XlOA offers driver support for: n
MS-DOS or PC-DOS n
Windows w OS/2 n
NetWare n
SC0 UNIX
These drivers also support installation of two BT-XlOA controllers and work with a maximum of four drives per controller. Please check the
README in the Novell driver diskette for further details. Depending on the product purchased, not all drivers listed are included.
S
P E C I F I C A T I O N S
Refer to table 1-l for a summary of the physical and electrical specifications.
Table l-l. Specifications
Performance
Hardware disk mirroring support for all operating systems
Green Cache: power saving support for both controller and drive(s)
Effective disk seek time: < 0.3 msec
Maximum DTR (Disk-to-Cache): 5MB/sec
Maximum DTR (ISA Bus-to-Cache): 5MB/sec
Sustained DTR (CoreTest):
BT-51 OA: 2.6MB/sec
BT-41 OA:
1 SMB/sec (50MHz)
BT-91 OA:
12MB/sec (33MHz)
Cache memory hit ratio: cache memory dependent
Introduction I 1-3
डाउनलोड
विज्ञापन