Cache DRAM Installation. BusLogic BT-XlO A
विज्ञापन
विज्ञापन
Note that the jumper setting for Pin l-4/ JP3 should match the INT Selection in the AutoIDE’s Controller Option Select module.
Pin 5
0*
1
IDE IRQ Channel
14
15
Controller
I/O Port
Primary
Secondary
Port Address lFO- lF7
170- 177
0 = jumper installed 1 = jumper removed
* = default
Pin 5/JP3 selects the board’s I/O port. When two controllers are installed, use this option to indicate which card is the primary and which serves as the secondary controller. Note that the jumper setting for Pin 5/JP3 should match the value for the Controller I/O Port option in the AutoIDE’s
Controller Option Select module.
Damping Resistor Bypass Jumpers (JDRO and JDRl)
JDRO and JDRl are used to short (place a connector over the jumper) the resistors associated with the first and secondary IDE bus, respectively.
These two jumpers are used to avoid possible hard drive (HDD) incompatibility due to different noise filter implementations in assorted HDDs. The default setting, jumper removed, is suitable for most HDDs.
JDRO JDRI
Jumper
JDRO if HDD filtering is required for primary I/O address
Jumper JDRl if HDD filtering is required for secondary I/O address
Figure 2-2. JDRO and JDRl Jumpering
C
ACHE
DRAM
I
NSTALLATION
The BT-XlOA uses Dynamic Random Access Memory (DRAM) in the form of SIMMs for its cache operation. You must install at least one pair of SIMMs for caching.
The BT-XlOA has four SIMM sockets, arranged in two separate banks. You must install 256KB/lMB/4MB f&t page mode SIMMs, with a minimum rated access of 8Ons or faster. These can be mixed in any combination, however, two SIMMs installed in the same bank must be the same size and speed. Bank0 must be installed with DRAM for proper operation and
Bank1 is optional.
SIMM specification: 256KB/l MB/4MB fast page
mode 80ns or faster
BankO: (256KB x 2)/(1 MB x 2) /(4MB x 2)
Bank1
:
(OMB x 2)/(256KB x 2)/(1 MB x 2)/(4MB x 2)
2-4 I ET-XlOA IDE Caching Controller
Configuration Options I 2-5
डाउनलोड
विज्ञापन