Pre-Installation Notes. BusLogic BT-XlO A
विज्ञापन
विज्ञापन
40-pin
IDE cable* connection
On-board
CPU
Jumper on selects
IRQ14 -
(default, shown)
Nojumperselects IRQ15
Minimum installation
SIMMS in Bank0 for caching l
Pin 1 indicated by colored stripe on cable
Speaker LED cable cable connection connection
Figure 3-4. Model BT-91OA Caching Controller
PREINSTALLATION N
O T E S
If you are upgrading an existing IDE hard drive subsystem, it is advisable to do a complete file-by-file (as opposed to image) backup of your data to removable media.
The BT-XlOA requires a specific bus slot, depending on which model you purchased, and, for most installations, can be treated as a direct replacement for an IDE hard bus controller (or “paddleboard”). If another IDE bus controller is to coexist with the BT-XlOA, then these two controllers must be set as primary and secondary, respectively (refer to the AutoIDE’s Controller I/O Port module description in Section 4). Also, only one of the two controllers can enable its floppy; the other one must be disabled or removed. If another IDE adapter is installed, you have to set the BT-XlOA’s
ROM address prior to that of the IDE adapter.
3-4 I
ET-XiOA IDE Caching Controller
*
M
ODEL
BT=Xl OA I
N S T A L L A T I O N
1.
2.
Before you install the controller card, install the SIMMs for cache memory.
For the BT-910A, set JP3 to select the correct interrupt and I/O port address values for this card. See Section 2 for details on these hardware configuration options.
Power down the host system.
Referring to the host system owner’s manual, open the case to gain access to the motherboard and expansion slots. If the computer has been on, wait a few minutes until the power supply case has cooled down inside the computer. If the power supply case is cold, touch it to discharge any static electricity that may be on your clothes or body. If a disk drive controller board is installed, remove all connecting cables to the board and then lift it out of the host computer.
3.
4.
Remove the mounting screw and the existing bracket from the rear panel behind the slot that has been selected for insertion of the BT-
XlOA.
Press the BT-XlOA downward into the selected slot, align the mounting bracket, and reinstall the mounting screw.
Caution:
Make sure that the board is properly seated in the slot.
5.
BT-410A/BT-5ZOA Only: Connect the 34-pin flat cable to CN3 by aligning its colored edge (usually red) with Pin 1 of CN3. Connect the other end to the floppy disk drive.
AZZ Models: If you are attaching a single new or used IDE drive to the
BT-XlOA, connect the drive to the IDE BUS1 connector, CNl, on the
BT-XlOA using either an existing or the supplied 40-pin data/control cable.
If you are attaching two or more IDE drives to the BT-XlOA, see the following rules before continuing. Also refer to the advanced installation instructions in Section 4 for further details regarding mirroring and linking configurations.
Installation I 3-5
डाउनलोड
विज्ञापन