Reference Documents. BusLogic BT-XlO A
إعلان
إعلان
Table l-1. Specifications (continued)
Technical
Microprocessor: 8OC286 (BT-51 OA, BT-41 OA and BT-91 OA)
Bus standard: 16-bit ISA Bus (BT-510A); 32-bit Bus (VL: BT-41 OA, PCI: BT-91 OA)
Cache DRAM: 80ns (or faster) 256KB/l MB/4MB SlMMs and can be mixed
Flexible cache expandability: from 512KB to 16MB
Maximum I/O bus speed: 12MHz (BT-510A); 25-50MHz (BT-41 OA: same as motherboard clock); 33MHz (BT-9lOA)
Maximum 4 IDE drives for each controller; maximum two controllers
Maximum 4GB capacity per drive
Maximum floppy drives supported: 2 (for BT-41 OA and BT-51 OA only)
ROM addressing: on-screen selectable
Functional
Auto drive parameter scanning make plug-and-play installation possible
Compatible with all major operating systems and 32-bit driver support
WD-1003 emulation mode support
Booting drive can be switched among multiple drives controlled
by your controller
Track-remapping support for drive capacity over 528MB under DOS environment
Enhanced INT 13 BIOS relocation
Track remapping and automatic type table creation
Caching algorithms: fully associated LRU, automatic read ahead, deferred write back, and elevated seeking
Direct replacement for standard AT Bus interface card without reformatting the drive(s)
R
E F E R E N C E
D
O C U M E N T S
To install the BT-XlOA you should have the following documents in addition to this installation guide: n n
Operating system installation and user’s guide
The system’s installation and set-up guide
H
A R D W A R E
R
E Q U I R E M E N T S
While you can install up to two IDE Cache Controllers, the following list assumes you are installing one controller in your host system: n n
One
available 16-bit expansion slot in your host system
DC power for an internal 3.5” or 5.25” IDE drive n
An
IDE hard drive n
One
40-pin and 34-pin ribbon cable to connect internal IDE and floppy (BT-410A and BT-510A only) drives
S
O F T W A R E
R
E Q U I R E M E N T S
For full 32-bit addressing with the BT-410A and BT-910A, you will need the enclosed diskette which includes operating system device drivers for installation. No drivers are required for BT-510A installation and use under
DOS. However, depending on your configuration of the BT-510A, drivers may be required for other operating systems.
Introduction
I l-5
1-4 I ET-XlOA IDE Caching Controller
تنزيل
إعلان