Log
This group includes commands specific to the internal log.
Table F-33: Admin > Log Commands
Command
*DBGPPPLVL
*DBGIPLVL
*DBGCOMMLVL
*DBGETHLVL
*DBGDHCPLVL
Description
Sets the logging level for the PPP stack.
•
n=0: No logging
•
n=1: Log client events (default)
•
n=2: Log server events
•
n=3: Log client and Server events
Sets the logging level for the IP subsystem.
•
n=0: No logging
•
n=1: Log errors (i.e. invalid/corrupt packets, etc.).
•
n=2: Log the header of all received packets. Note that this can quickly exhaust available space for the event log.
•
n=3: Log the header of all received and sent packets. Note that this can quickly exhaust available space for the event log.
Set the logging level for the host or module COM port.
•
n=0: No logging
•
n=1: Host COM Port
•
n=2: Module COM Port
Sets the logging level for the Ethernet port.
•
n=0: No logging
•
n=1: Log errors: invalid/corrupt packets, etc.
•
n=2: Log the header of all received packets. Note that this can quickly exhaust available space for the event log.
Enable or disable internal DHCP logging.
•
n=0: No logging
•
n=1: Log DHCP events.
Miscellaneous
Table F-34: Miscellaneous Commands
Command Description
+++
AT Escape Sequence detection.
•
n=0 : Enable
•
n=1 : Disable
Rev. 6 May.13
283
ALEOS User Guide
Table F-34: Miscellaneous Commands (Continued)
Command Description
*HOSTMODE?
avms<server><interval>
The current host mode (AT, PPP, UDP, etc.). If the device is not in AT mode, Telnet into the device to execute this command.
Enables device management using AirVantage
<server> = server’s URL
<interval> = interval between heartbeat messages sent by the AirLink device (in minutes)
Recommended interval range is 15 minutes–10080 minutes (1 week).
Possible interval range is 1 minute–65000 minutes.
Set the interval to “0” to disable heartbeat messages.
When this command is entered, the AirLink device sends a heartbeat message immediately, and then waits the interval before sending another heartbeat message.
284 4112515
