Chapter 6. Working with Recorded Data

Chapter 6. Working with Recorded Data

The DMS Go combines a thickness gauge with sophisticated data recording capabilities. It permits an operator to save and organize all thickness measurement data (along with comments, A-scan graphics, B-scan cross-sectional profiles, Micro-Grids, and other information) into data files for editing, evaluation and export to PCs via the SD card or the USB port.

6.1

Selecting a Data File (DR - EXPLORER)

1.

Use the joystick ( ) to select the function titled

EXPLORER in the DR menu.

M ove the joystick right ( ) to open the function.

If you have created files, the display appears similar to Figure 29 on the next page.

DMS Go Operator’s Manual 107

Chapter 6. Working with Recorded Data

6.1

Selecting a Data File (DR - EXPLORER) (cont.)

Figure 29: The Explorer Option (with Created Files)

Use the joystick to select the file, and then press F2 or center-press ( ) to confirm your selection. The DMS Go asks, “NOTICE Show

File’s Properties?” Move the joystick to Yes, and the

PROPERTIES function opens (Figure 31 on page 112).

108 DMS Go Operator’s Manual

Chapter 6. Working with Recorded Data

6.1

Selecting a Data File (DR - EXPLORER) (cont.)

To select a second file, scroll to the second file and press ENTER to confirm your selection. The DMS Go closes the first file and opens the second file.

Note: Only one file can be open at any given time.

To delete a file, scroll to the file and press F3 (

DELETE). The DMS Go asks for confirmation. Press F2 or center-press YES.

To exit the Explorer function, press F4 (

EXIT). Note, however, that the currently open file remains on the display.

DMS Go Operator’s Manual 109