advertisement
00743A V8600_eng1 3/11/05 2:15 PM Page 19
C O N N E C T I O N S
Connecting a Power Cord & Auto Setup
1
Your DVD-VCR's power cord should be plugged into a standard 120V/60Hz wall outlet. Avoid pressing any buttons on the remote control or on the unit during Auto Setup. While your DVD-VCR is running Auto Setup, “Auto” will blink. When
Auto Setup is complete, the current time will be displayed on the front panel. If Auto Setup fails to locate a channel to set the clock, you should set the clock manually. (See page 22 to 23.)
You must have the antenna connected to set the Auto Clock
(See pages 11~12)
2
Turn on the power by pressing the POWER button on the remote control or on the front panel.
3
Turn on your TV by pressing the POWER button on the TV remote control.
ENG-19
advertisement