Operating Instructions ENERCON E-40

ENERCON E-40 Operation instructions

Page 82 of 96

9 S

TARTING AND

S

TOPPING OF THE

E-40 (

BRIEF INSTRUCTION

)

Before starting to operate the E-40, it is absolutely necessary that you read the chapters 2, 3, 5 and 6.

9.1 Startup of the E-40

If the main switch on the control cabinet is not already in the "ON" position, set it to "ON". The "manual / automatic" switch must be set to automatic.

Main switch

ON

Then set the "start / stop" switch to "start“ .

The starting routine begins automatically after several minutes of wind measurement

Start Stop or:

When you have set the "start / stop" switch to "start", press the "quick start" button.

This suppresses the wind measurement and the starting process begins already after a few seconds.

Quick start

9.2 Stopping the E-40

In order to stop the E-40, set the "start / stop" switch to the "stop" position. The turbine stops. Do not actuate the main switch for this purpose.

Start Stop

Starting and Stopping of the E-40 (brief instruction)