3-2. Using the multimedia system
Select “OK” when the connection status changes from “Connecting...” to “Connected”.
If an error message is displayed, follow the guidance on the screen to try again.
Registration can be performed from screens other than the
“Bluetooth Setup” screen.
■ When registering from the “Bluetooth Audio” screen
Display the “Bluetooth Audio” screen. (
P. 257)
Select “Select Device”.
Follow the steps in “How to register a Bluetooth
®
device” from
“STEP 2”. (
P. 286)
■ Deleting a Bluetooth
®
device
Display the “Bluetooth Setup” screen. (
P. 284)
Select “Remove”.
Select the desired device.
A confirmation message will be displayed, select “Yes” to delete the device.
Check that a confirmation screen is displayed when the operation is complete.
3
287
3-2. Using the multimedia system
Connecting a Bluetooth
®
device
Up to 5 Bluetooth
®
devices (Phones (HFP) and audio players (AVP)) can be registered.
If more than 1 Bluetooth
®
device has been registered, select which device to connect to.
Press the “SETUP” button.
Select “Bluetooth” on the “Setup” screen.
Select the device to be connected.
Supported profile icons will be displayed.
Phone
Audio player
Supported profile icons for currently connected devices will illuminate.
Dimmed icons can be selected to connect to the function directly.
■ Auto connection
To turn auto connection mode on, set “Bluetooth Power” to on.
(
P. 291)
When you register a phone, auto connection will be activated.
Always set it to this mode and leave the Bluetooth
®
phone in a place where a connection can be established.
When the engine switch is turned to the “ACC” or “ON” position, the system will search for a nearby cellular phone you have registered.
Next, the system automatically connects with the most recent of the phones connected to in the past. Then, the connection result is displayed.
288
3-2. Using the multimedia system
■
Manual connection
When auto connection has failed or “Bluetooth Power” is turned off, you must connect the Bluetooth
®
device manually.
Follow the steps in “Connecting a Bluetooth
®
device” from
“STEP 1”. (
P. 288)
■
Connecting a Bluetooth
®
audio player
Registering an additional device
Select “Select Device” on the “Bluetooth Audio” screen.
For more information:
P. 286
Selecting a registered device
Select “Select Device” on the “Bluetooth Audio” screen.
For more information:
P. 288
3
■ Reconnecting a Bluetooth
®
phone
If the system cannot connect due to poor signal strength with the engine switch in the “ACC” or “ON” position, the system will automatically attempt to reconnect.
If the phone is turned off, the system will not attempt to reconnect. In this case, the connection must be made manually, or the phone must be reselected.
289
