advertisement
Terminal Configuration
Connect the equipment as described above. The following screens will be displayed during the configuration of your terminal:
As your terminal powers up it will go from a grey screen to this and eventually to the following screen.
Once a connection has been made various files will be downloaded to the terminal.
Type in your merchant number and then press .
Various file names will be displayed before the terminal disconnects from the configuration host.
The terminal will attempt to get a
GPRS Signal.
If prompted confirm the date by pressing if it is correct, or type in correct date and then press .
The terminal will contact the configuration host.
If prompted confirm the time by pressing if it is correct, or type in the correct time and then press .
Page 23 Move/3500 User Guide Copyright© 2017 Ingenico
Page 24
The terminal will power cycle.
The terminal may then contact any/all of the acquirers to for verification.
Type in your preferred
‘Supervisor
Code’ and then press
Type in your preferred
‘Supervisor
Code’ and then press .
Re-type your new ‘Supervisor
Code’ and then press .
The ‘Logo’ and text ‘AUTH
HOST’ will differ for each Acquirer
The terminal will contact the configuration host.
The terminal will upload the status of its applications and print a list of card types that will be accepted.
Press to acknowledge the change.
Terminal will return to the ‘Idle
Screen’ if installation is successful.
Move/3500 User Guide Copyright© 2017 Ingenico
advertisement
Related manuals
advertisement